3D Systems Geomagic Touch Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarki 3D 3D Systems Geomagic Touch. 3D Systems Geomagic Touch 5 stron. Haptic device

Drukuj stronę

GEOMAGIC TOUCH QUICK START GUIDE

This quick start guide is a high-level overview of the steps you need to take to install, connect, and start to use the Geomagic Touch

haptic device. For detailed information, see the Geomagic Touch User Guide available on the

EXISTING USERS:

Remove any previous version of the PHANToM Device Driver that is installed on the computer:

•

Win 7 or Win 8: Control Panel > Programs and Features > Uninstall a program

Delete all older setup files in the following location: C:\Users\Public\Documents\SensAble\

PERFORM THE FOLLOWING STEPS:

Go to

http://support.geomagic.com

support.geomagic.com, from Products select Scanners and Hardware, then select the Touch device and Downloads).

After the device driver has installed, select the option in the installer to

For a computer with no internet connection, follow the

manual (included with your adapter).

Connect the Ethernet Adapter, if you have not already installed the driver – wait a few minutes for the driver to be automatically

installed (you must have internet connection).

Connect the Geomagic Touch Device (Ethernet cable and power supply) as shown below. Connect the Ethernet cable to the

Adapter and then to either the

connections check Appendix B: Alternate Connections in the Geomagic Touch User Guide.

USB Port

Check the Network Status Indicator on the Windows 7 or 8 taskbar.

3D Systems, Inc.

to download and install the latest version of the Geomagic Touch Device Driver. (Go to

Driver Installation

ETH 1

ETH 2

ports on the device. This is the 3D recommended connection. For alternative

Ethernet Adapter Port

http://support.geomagic.com

Restart Your

Computer.

instructions found on page 2 of the Ethernet Adapter

website.

ETH 1 or ETH 2

http://