Aerial WT 230-E Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Osuszacz powietrza Aerial WT 230-E. Aerial WT 230-E 17 stron. Dehumidifier / laundry dryer
2) The fan of the dehumidifier does not work, the compressor still turns.
- The unit is in defrost mode. The green neon lights up (see Pt. 8 – Pos 5). In this
case the compressor still runs and the fan does not run. After some minutes, the
unit will start with regular working.
3) The complete dryer is out of operation. Fan and compressor does not run
- Is the dryer switched on? ´
- Is the unit supplied with voltage?
AD 2xx / WT 2xx: On-/Off-switch (Pt. 8.1 / 8.2 – Pos. 6) must be
o
in Pos. I and light up
WT 2xx-E: neon for operation (Pt.8.3 – Pos. 6) must light up.
o
- Check the main cable, an additional cable, the socket and the main fuse.
- The humidity value adjusted at the hygrostat is achieved. The dryer will start again
after exceeding the adjusted humidity. The yellow neon (Pt. 8 – Pos. 3) lights up.
AD 2xx / WT 2xx: The dryer switches on again when the humidity
o
increases to a value above the adjusted value.
WT 2xx-E: The dryer has to be switched on at the On-Switch (Pt.
o
8.3 – Pos 7) to start a new drying process.
4) Strong icing up at the evaporator.
- Put the dryer into a room with min. +10°C room temperature and wait until
complete ice is defrosted. Switch on the unit again (in that room with min. +10°C)
and let work for approx 3 hours. If there is icing up again, please contact your
dealer. Otherwise make sure that the unit is only been used in rooms with more
than +3°C. Also the storage of the dehumidifier at inadmissible temperature
conditions can lead to damages / problems while immediate switch-on.
5) The humidity adjusted at the hygrostat does not become achieved and/or the
device does not switch off automatic.:
- Is the hygrostat adjusted on a value lower than 40 – 45% r.h.? Humidity values
with a minimum of 40 % - 45 % r.h. can be achieved with a condensation dryer.
Adjust the hygrostat to a reachable value.
- Is the unit with enough capacity for your application? The air changing, number of
the persons in the room, volume of wet clothes and open water surfaces decide
on the humidity burden in the room. Let calculate the necessary capacity from
your dealer
- Is there a lot of water in the walls or the floor? In that case the dryer needs some
time to remove that water and to achieve an acceptable humidity in that room.
ATTENTION
The appliance must be repaired by trained and expert personnel only. In the case
of interventions by unauthorized people, any and all warranty claims shall become
null and void!
If you have any questions regarding defects and malfunctions of AERIAL-air dryers
we recommend get in touch with your supplier.
The producer AERIAL GmbH you reach under 0049-40-526879-0 or www.aerial.de
Page 16 of 17