DISPLAYLITE DST-4600T Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Monitor DISPLAYLITE DST-4600T. DISPLAYLITE DST-4600T 10 stron. Capacitive touch table

Drukuj stronę

Cleaning and Safety

Power off the product and remove the power cable. Pull the

power cable by the plug and never touch with wet hands.

(Electrical shock may result.)

Wipe the product's screen using a clean, soft, dry cloth.

(Otherwise product scratching may result).

Use a moist soft cloth and wring thoroughly before wiping

to clean the exterior of the product.

(Otherwise damage may result).

Do not use detergent that contains alcohol or other solvents.

Use cleaning solvents intended only for computer displays.

(Damage to the product surface may result).

Connect the power cable to the product after cleaning the product

and drying completely.

(Product failure, electrical shock or fire may result).

IV Usage

Before using the product, please check the I/O switch on the side of the product.

This switch controls power for the entire unit. In the "O" setting, neither the Display

or Device Power Port will receive power. In the "I" setting, the Device Power Port

will remain constantly powered and the display can be turned on using the power

button.

Start

Set the I/O switch to the "I" setting. Push the Power Button inward and release.

A blue light will emit to indicate the display is now on. Wait a few seconds for the

display to power on fully. The contents of your Mini PC or Android device should

be displayed on the screen after a few moments. If the device does not appear

on the screen check the power status of the device, as it may not be powered on.

Configuration & Touch Calibration

Once the product's Display and connected device are powered on, you may

operate the product. Touch should be calibrated automatically, as the table is

designed to be plug and play. If touch is calibrated improperly, please perform

a calibration using the touch calibration settings in Windows:

1. Open Windows Control Panel.

2. Open Tablet PC Settings and select calibrate.

3. Follow the Windows prompts and touch the screen to calibrate according to Windows.

Touch calibration for Android and other devices will vary. Consult your device manual

for details on how to calibrate touch. The product's speakers are set to operate

at 90% of their maximum output. To adjust the volume, you must utilize the audio

output controls in Windows or those of your connected device.

Other

Touch and visual performance depend greatly upon the specifications of the

connected device. Be sure that your device meets the minimum requirements

outlined in the product specifications on page 18.

Shut Down

The Display and operating Mini PC or Android device must be turned off

separately. First, shut down the Mini PC or Android device by using the OS

menu. To shut down the display, press the round power button. You may leave

the I/O switch on in the "I" setting if desired. If the Mini PC or Android device

needs to run while the Display is shut down, the I/O switch must remain in the

"I" setting. This is useful for performing upgrades or service on the device

without the need for the Display to remain powered on.