3D Systems wematter Atmosphere Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarki 3D 3D Systems wematter Atmosphere. 3D Systems wematter Atmosphere 11 stron.

PREPARATION AND SETUP

Place the Atmosphere within 2 m / 78.7 ft from the Gravity. Please place it with its back at least 10 cm / 3.9 inch from a wall to

allow for the hose and cabling to be installed. Reserve the following minimum dimensions for the most convenient access:

•

Width: 45 cm / 17.71 inch

•

Depth: 100 cm / 39.3 inch

•

Height: 100 cm / 39.3 inch

WARNING: IT IS NECESSARY TO PLACE THE ATMOSPHERE IN A WAY THAT ALLOWS YOU TO BE ABLE TO PULL THE

PLUG FROM THE MACHINE OR POWER OUTLET.

CAUTION: Always allow for the Atmosphere to have access to free flowing air at the bottom and the back to

maintain functionality.

Connect the Atmosphere to a wall socket that is working on a separate fuse to the Gravity.

To function the Atmosphere must be connected to the Gravity.

1. Connect an Ethernet cable to the Atmosphere's back and the RJ45 socket on the bottom back right corner of the Gravity. The

cable must be locked in position 2.

2. Connect the included hose to the push in fitting on the back of the Atmosphere and the push in fitting on the bottom back

right corner of the Gravity.

IMPORTANT!: The hose must at all times allow for free flow through it. Please pay attention so that the hose is

never compressed or folded.

Please contact 3D Systems Support if you want to move the equipment.

3D Systems, Inc.

p/n 74-D003, Rev. A