3D Systems ZPRINTER 150 Skrócona instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarki 3D 3D Systems ZPRINTER 150. 3D Systems ZPRINTER 150 16 stron.
Drukuj stronę
6.5 Clean the Parking Caps
(ZPrinter 250 Type 1 only)
Note: Parking caps are only installed on older ZPrinter 250 mod-
els (Type 1). On more recent ZPrinter 250 (Type 3) and on all
ZPrinter 150 models, the Parking Caps are not present.
Before you begin:
•
Get several dry paper towels and a cotton swab.
•
Get the squirt bottle filled with distilled water.
•
Wear disposable gloves.
•
Get the Pick and Syringe from the Accessories Kit.
1.
Lift the Parking Cap cover to a horizontal position and place
dry paper towels underneath.
2.
Squirt the distilled water onto the caps. Do not squirt water
onto the Build Bed.
3dscentral.3dsystems.com
3.
Use a cotton swab and dry paper towel to wipe the caps
clean. Use the pick if needed to remove any powder.
4.
Remove the paper towels from under the caps and wipe up
any excess water on the deck.
5.
Be sure the Parking Caps are completely dry before starting
your next build.
10