Acoustic Control NARCISSUS GAMMA Series Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pedał muzyczny Acoustic Control NARCISSUS GAMMA Series. Acoustic Control NARCISSUS GAMMA Series 2 stron.

Drukuj stronę

DC 9V Power Input Jack

You can power your GAMMA Series

pedal from a 9-volt regulated DC

adapter (plug polarity is positive on

the barrel and negative in the center).

2. Battery Capability

Use a Phillips head screwdriver to

remove 4 bottom screws to access

battery connection. High quality

alkaline 9-volt battery can be used for

approximately 12 hours of continual

operation. If pedal won't operate when

battery is installed, battery may be

discharged, and should be replaced

with a fresh, fully-charged battery. Or

connect a compatible power supply

for non-battery operation.

3. Footswitch

Push down the footswitch to toggle

between on and bypass status.

4. LED

When the LED is lit, the effect is on.

When it's off, the effect is bypassed.

(Bottom removed for battery access)

5. INPUT Jack

¼" mono audio jack, to receive the

signal from your guitar or a previous

pedal. Pedal draws power only when

this jack has a plug inserted.

6. OUTPUT Jack

¼" mono audio jack, outputs the signal.

LEVEL Knob

Adjusts the volume of the echoes from

minimum, to maximum. The level of

your "dry" guitar sound is not affected.

8. TIME Knob

Adjusts the timing of the echoes, from

25ms to 600ms, letting you achieve

tight "slap back" echo, thickening

delays, or quarter note-timed echoes

down to 100 bpm.

9. ECHOES Knob

Determines how many times a given echo

will repeat, with settings near maximum

allowing each echo to increase

in volume, to create a continuous

"crashing" of darkening echoes.

AcousticControlCorp.com

Underside of pedal

21510408 2209