3D Upfitters AnkerMake M5 Instrukcja instalacji - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Obudowa 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18 stron.

They've been running like that for years with no clogging, and even with no venting of

the power supplies, we've never had a power supply fail either. Your mileage may vary

as it depends on many variables, such as ﬁlament quality and the quality of the power

supply in your printer.

If you're looking for the highest possible temperature, try turning the bed heater

on for an hour before printing.

The other part of the equation is the printer design. Those printers where the hot end is

at the top of the enclosure make it easier to achieve higher temperatures because the

hot air rises to the top, and the vertical hot end position is ﬁxed. Those printers with

the hot ends at the bottom will always have more problems managing temperature

simply because the temperature is more likely to vary as the hot end goes from the

bottom to the top of the enclosure.

If you're looking to achieve a particular temperature with your enclosure, let us know,

and we'll give some advice on how to manage, but it's not that hard:

Lower Temperature = More Air Flow

Higher Temperature = Less Air Flow