CAME ZA3P Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Panel sterowania CAME ZA3P. CAME ZA3P 13 stron. Control panel for 230vgearmotors
Również dla CAME ZA3P: Instrukcja instalacji (13 strony)

Drukuj stronę
CAME ZA3P Instrukcja instalacji
be effective. • All maintained-action switches that are connected to the control panel
must be positioned so that the maneuvering area is completely visible from the switches,
yet far enough away from any moving parts. • Make sure that the operator has been
properly adjusted and that any associated safety and protection devices, as well as the
gearmotor's manual release, are working properly. • If the power-supply cable is dama-
ged, it must be replaced by the manufacturer or by the licensed technical-assistance
center or by duly trained, skilled staff, to prevent any risks. • During all phases of the
installation make sure you have cut off the mains power source. • The electrical cables
must run through corresponding tubes or conduits to ensure suitable protection against
mechanical damage and they must not come into contact with parts that could heat up
during use. • Make sure you have set up a suitable dual pole cut off device along the
power supply that is compliant with the installation rules. It should completely cut off
the power supply according to category III surcharge conditions. • If the control panel is
used for automating guided parts in residential settings, permanently fit the entrapment-
hazard-warning signage, so that it is clearly visible or close enough to all command and
control devices. After installing, make sure that the operator is properly adjusted and
that the guided part, in case it touches any object that is 50 mm high off the ground,
inverts its movement or that the object may easily be removed (for operators that have
built-in anti-entrapment systems that depend on coming into contact with the lower
edge of the guided part). Also make sure that the guided part does not extend onto any
public pedestrian passages or onto the street. • Store this manual inside the technical
folder, along with the installation manuals of the other devices in the system. Remember
to hand over to the end users all the operating manuals of the products that make up
the final machinery.