3DHobbyShop.com Yak 54 Instrukcja montażu - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka 3DHobbyShop.com Yak 54. 3DHobbyShop.com Yak 54 18 stron. 55” arf rc aircraft

Remove the canopy hatch. Use THIN CA glue to attach one side of the Velcro to the battery tray as

shown. Stick the opposite side of the velcro to your battery pack. Use at least 2 velcro straps to retain

the battery in the airplane, as shown.

Mount your receiver to the fuselage sidewall or a fuselage former in a convenient place using velcro, hot

glue, or foam tape. Connect all of the radio connections with appropriate servo extensions. Because

there are two elevator servos, one will need to run in the reverse direction from the other.

We recommend temporarily removing all of the servo horns on your aircraft before turning the radio setup

in the airplane on for the first time. Once your radio is powered, center all servo trims and sub-trims, then

re-install all servo horns.

WITHOUT the prop installed, reverse servos as necessary. NEVER do servo reversing on an

airplane with the propeller installed, you may accidentally reverse the throttle channel, causing

injury.

WITHOUT the prop, run your motor, check for correct direction of rotation. Reversing motor rotation is

accomplished either within your ESC programming, or by reversing the connection of any two of the

motor-to-ESC wires.

Make sure the routing of radio wires inside the airplane is secure. Use nylon zip-ties and CA glue as

necessary to make sure your radio wires will not become tangled in the rudder servo arm or rudder pull-

pull cables.

Remove the covering from two bays on the bottom of the airplane as shown, to allow cooling-air to exit.