3DLabPrint Focke-Wulf Ta 152 C Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zabawka 3DLabPrint Focke-Wulf Ta 152 C. 3DLabPrint Focke-Wulf Ta 152 C 9 stron. Fully 3d printable upgrade to short wing
Drukuj stronę5. Assembly of printed parts
5.1 Wing assembly Ta 152 C
Glue wing parts L1-L4 perfectly together. The new 3DLabPrint lock system will help you.
Repeat for the right side. Glue both halves of the wing together. Use the CA glue, (position
locks and pins will help you to align the parts), and use activator to speed up the glue curing.
On a flat surface glue the ailerons L1-L4 and repeat for the right side. Use a suitable 0,8mm -
1,2mm carbon rod or wire as a hinge for the ailerons. Just slide it in, there's no need to glue
the hinge for easy aileron or servo replacement.
See example video guide for H version of Ta 152 #4
you will need:
R wing
wing pins
PLA
wing L1
57g/2.01oz
CA Glue medium viscosity+ activator
0,8 - 1,2 mm carbon or steel wire for aileron hinge
Snap knife, Some cloth for wiping CA glue...
wing L2
42g/1.48oz
... print your plane | www.3DLabPrint.com
aileron L1
5,4g/0.19oz
(2,7g/0.09oz) LW
(2,7g/0.09oz) LW
wing L3
24,5g/0.86oz
(12,3g/0.43oz) LW
6
page
aileron L2
5,4g/0.19oz
aileron L3
5,9g/0.20oz
(2,9g/0.10oz) LW
wing L4
2g/0.07oz
(1g/0.04oz) LW
aileron L4
2g/0.07oz
(1g/0.04oz) LW