Balmar DDC-12/24 Instrukcja instalacji i obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Ładowarka Balmar DDC-12/24. Balmar DDC-12/24 10 stron. Digital duo charge

Drukuj stronę
Digital Duo Charge Troubleshooting
Symptom
No Lights/No Output
Interference at radio, autopilot or
navigation equipment when Digital
Duo Charge is active
Output voltage is not appropriate for
battery type selected
No Output. #4 LED blinks once inter-
mittent
No Output. #4 LED blinks twice inter-
mittent
No Output. #4 LED blinks three times
intermittent
No Output. #4 LED blinks four times
intermittent
No Output. #4 LED blinks five times in-
termittent
No Output. #4 LED blinks six times in-
termittent
www.balmar.net / Customer Service: +1 (360) 435-6100 x1 / Technical Support: +1 (360) 435-6100 x3
Cause/Solution
1.
No voltage at input wire or ON/OFF wire – Check wiring and repair.
2.
Bad fusing on input wire – Replace 30A fuse in input cable.
3.
Voltage too low at house battery bank – Check house battery charging system.
4.
Starting battery demanding >30A – Install solenoid and manual over-ride switch. Check grounding.
5.
Bad Duo Charge unit – Contact Balmar Customer Service at 360-435-6100 or at [email protected].
1.
Input, Output or ON/OFF wires causing interference – Re-route wiring. Check system grounding.
2.
Output wire is coiled – Uncoil any surplus wire and re-arrange to ensure noise is reduced.
3.
Duo Charge is mounted too close to electronics – Relocate Duo Charge.
4.
Frequency interference – Install noise reduction filter on electronics power wire.
1.
Wrong battery program selected – Verify program and re-program as described above.
2.
Voltage drop in output cable – Check wiring resistance and repair as needed.
3.
Voltage drop in input cable – Check wiring resistance and repair as needed.
4.
Voltage drop in output cable – Check wiring resistance and repair as needed.
1.
High system temperature – Determine source of overheating and repair.
1.
Start battery voltage too high – Inspect starting battery for secondary charge sources and correct.
1.
House battery voltage too low – Correct charging source for house battery bank.
2.
House battery voltage too low – Check wiring resistance in Input wire and repair as needed.
1.
House battery voltage too high – Correct charging source for house battery bank.
1.
Start battery temperature too high – Shut down system. CAREFULLY inspect starting battery for signs of
overheating. Repair condition and/or replace starting battery.
2.
Bad Temperature Sensor cable – Check wiring resistance (approx. 34-40k). Repair or replace Temperature
Sensor cable.
3.
Bad system grounding – Test ground-side resistance between batteries and charging system. Repair.
1.
Voltage too low at ON/OFF terminal – Repair or relocate ON/OFF wire.
4
5
3
1
Tech Service is available Monday - Friday (8:30am - 7:30pm EST)
6
7
8
9
2
8