AkitikA PAT5RCA Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wzmacniacz AkitikA PAT5RCA. AkitikA PAT5RCA 12 stron. Dynaco pat-5 preamp replacement rca jack
Drukuj stronęSection 1: About This Manual
This manual gives the information needed to build and install new RCA jacks into
Dynaco's PAT-5 Preamp.
Who Should Attempt this Project?
You can build this kit if you can:
1. Solder (using normal rosin core solder and a soldering iron).
2. Use simple hand tools like screwdrivers, wire cutters, and pliers.
3. Read and follow directions.
It helps if you:
1. know a bit about electronics, or
2. have a friend who knows a bit about electronics
3. can get to YouTube to watch a few helpful videos about the assembly process
(none are posted as of this version of the manual).
Tools you'll need
You'll need the following tools:
1. Phillips screwdriver (#1 and #2), regular screw-drivers.
2. Pliers or nut drivers suitable for #4 and #6 hardware
3. needle nose pliers (helpful, but not strictly necessary)
4. pencil type soldering iron of 25 to 50 Watts (no huge honking soldering guns or
blowtorches)
5. wire cutters and strippers
Helpful Tools
These tools aren't strictly necessary, but make building the kit easier.
1. magnifying glass, if you're over 42!
Project Overview
The project consists of the following steps:
1. Building the new RCA jack fields and adding ground wires.
2. Opening up the PAT-5.
3. Transferring two capacitors and all the wires from the old jacks to the new jacks.
4. Reinstalling the new RCA jacks.
5. Closing up the PAT-5.
Warning
This kit is a surprising amount of work. Be sure to take breaks as you work through the
steps.
Page 3 of 12