3DR LiveView Podręcznik użytkownika

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria do kamer 3DR LiveView. 3DR LiveView 2 stron. Kit for gopro

LiveView

Kit for GoPro

™

User Guide

Transmitter Assembly

Attach a velcro strip to the flat side of the video transmitter to prepare it

to mount to the copter. Connect the air antenna (red) to the transmitter.

The transmitter has two ports: a two-wire port and a three-wire

port. Connect the black connector on the splitter cable to the

transmitter's two-wire port. The transmitter's three-wire port will

connect to the GoPro video cable. On the end of the GoPro video

cable with two connectors, select the connector with the more

widely-set wires. Orient the connector with the metal pins facing in

the same direction as the velcro, and connect to the transmitter's

three-wire port.

GoPro video cable

Antenna

Splitter cable

GoPro video cable

Select the connector

with the larger space

between the two wires.

Complete transmitter wiring

Parts

Monitor

Splitter cable

Mounting bracket

Air antenna

Ground antennas (2)

Video transmitter

GoPro video cable

Mounting velcro

GoPro HERO Assembly

For X8+, use the GoPro video cable pre-installed onto the vehicle.

For other vehicles, use the GoPro video cable provided with this kit.

Connect the micro-USB end of the cable to the GoPro's micro-USB port.

GoPro video cable to GoPro HERO wiring

Insert the mounting screw provided with the cable through the cable

plate and attach to the hole in the gimbal marked below. This will secure

the cable to the gimbal.

Secure cable to gimbal

Important note: Make sure that the WiFi on your GoPro is

turned OFF at all times when in use with your copter. The WiFi

signal can interfere with the copter's radio communication and

cause unexpected behavior.