Balteco VARIO Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kabiny prysznicowe Balteco VARIO. Balteco VARIO 17 stron.

VARIO ENG

2.5. SETUP

Icon on the display. No quick button!

Time setup

Open "setup" screen to set the time. Use buttons X/Y to select the

setup icon shown on the display and press OK button, "setup" sub-

menu will open. See the picture.

Use X/Y buttons to select time setup icon and then press OK but-

ton, the hour reading will start blinking. Blinking hour reading can

be adjusted by using buttons X/Y. After setting the hour reading to

desired number you may also set the minutes reading by pressing

button P. Only the minute reading will start blinking after pressing

button P. blinking minute reading can be adjusted by using buttons

X/Y. In order to save the time set in blinking mode, press OK button.

If the time has been in setup (blinking) mode for 20 seconds and no

buttons have been pushed, the time will automatically restore to the

settings used before entering into setup mode and display will stop

showing "setup" screen.

Display will stop showing "setup" screen if you:

- have not pressed any of the buttons within 20 seconds,

- use buttons X/Y to select exit setup icon and press OK button.

- press button E, i.e. return to main menu

NB! Time always needs to be set after:

- connecting the product to the power network,

- power failure

The need to set the time is indicated by reading 00:00 on the display.

Setting timer for steam function

In order to set the timer, you need to open "setup" submenu. Use

X/Y buttons to select setup icon shown on the display, press OK

button and "setup" submenu will open. See the figure.

Use buttons X/Y to select steam function timer icon and press OK

button, the hour reading of the timer will start to blink. The blinking

reading shows the most recently set time. Blinking hour reading can

be adjusted by using buttons X/Y. After setting the hour reading

you may also set the minute reading by pressing button P. Only the

minute reading will start to blink after pressing button P. The blink-

ing minute reading can be adjusted at 5 minute intervals, by using

buttons X/Y.