BALTENSWEILER OyO D 3 Instrukcja montażu i obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja montażu i obsługi dla Oświetlenie domowe BALTENSWEILER OyO D 3. BALTENSWEILER OyO D 3 5 stron.
Drukuj stronę
BALTENSWEILER
Operating instructions
The magnetic contacts must lie cleanly during operation so that
1
contact and consequently correct current conduction can be
ensured.
Correct
Switching ON / OFF and dimming via button on luminaire head:
2
Switching: Press the button shortly.
Dimming: Keep the button pressed (step dimming).
Important note: The luminaire must not be operated
with an external dimmer.
When adjusting the height or swivelling out the lamp, always
3
hold the telescopic rod firmly.
The ball joint in the ceiling flange has been tested and adjusted
4
at the factory.
Adjust the ball joint belatedly:
Disconnect the power supply during adjustment
(remove fuse).
Loosen the cover from the mounting plate − held in place mag-
netically (see also page 3 / section 5). Release the rods from the
ball joint if necessary (loosen the set screw in the ball joint). The
universal joint can be adjusted with two screws in the cylinder
(see sketch).
Then reassemble the cover and rods (according to the mounting
instructions on page 3 / section 5 to 8).
When the luminaire is completely mounted, the power
supply may be switched on again (switch on the fuse).
The 100° optic holds magnetically to the luminaire head.
5
With the 100° optic, wide beam lighting is achieved with better
glare control. It is particularly suitable for applications in which
wide and preferably glare-free illumination is desired.
Luminaire head without optics: The luminaire head has a small
anti-glare cone. Even without additional optics, good glare
control is achieved with the widest possible beam angle of 120°.
Other optics can be ordered separately:
Optic 60°: The 60° optic allows for a wider but still slightly ac-
centuated horizontal or vertical illumination of larger objects,
walls or tables.
Optic 20°: The 20° optic is suitable for applications in which
accent light is desired for targeted and punctual illumination
(e.g. for images or objects).
Package contents:
- Ceiling plate with cover, Telescopic rods with luminaire heads
- OyO D 2: 2 x optics 100° / OyO D 3: 3 x optics 100°
- Mounting material and Insulation tubes.
LICHT UND LEUCHTEN
Incorrect
www.baltensweiler.ch
3
Ceiling flange
Do NOT adjust this screw
(with the cable lug)!
Loosen or tighten
these 2 screws
accordingly.
100°
60°
20°
Tel. +41 41 429 00 30
Telescopic rod
3
5
1
Magnet must be
attached to the rod.
Luminaire head
2
Button
Cylinder bronze
washer
Mounting plate
Ball joint
4
Telescopic rod
Optic
5
Luminaire head
Optic 100°, Article no. 6000-63
(OyO D 2: 2 piece included in delivery,
OyO D 3: 3 piece included in delivery)
Optic 60°, Article no. 6000-62
(Not included in the scope of delivery)
Optic 20°, Article no. 6000-61
(Not included in the scope of delivery)
M 1203/32637/SaWa/20.05.2021
EN
4 / 5