Camfil FB Series Instrukcja instalacji, obsługi i konserwacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji, obsługi i konserwacji dla Systemy filtracji wody Camfil FB Series. Camfil FB Series 20 stron. Fluid seal bag-in/bag-out
Drukuj stronę
Bag-In/Bag-Out Concept
Consult your safety officer before beginning filter change-out, to assure all proper procedures are
followed for your application.
Note: Filtration housings that contain more than one filter/adsorber are equipped with filter removal rods.
Filtration housings containing multiple prefilters also are equipped with removal rods. The filter removal rod can
be operated from inside the change-out bag to aid in removing the second or third filter/adsorber inside the
housing. To operate the filter removal rod, grab the handle from inside the bag glove and pull filter/adsorber
towards you. It is recommended on all multi-filter change-outs that the first filter/adsorber be removed by hand
to lighten the load that will have to be pulled by the removal rod. Adsorbers are very heavy, and it may require
a hard pull to remove them from the housing. For filtration housing containing three (3) adsorbers, it may be
necessary to remove the second adsorber by reaching inside the filtration housing and pulling the adsorber out
by hand.
1. Before replacing a contaminated filter(s)/adsorber(s), the airflow through the filtration system must be
stopped. This can be performed by shutting-down the system, or bypassing the airflow through the system
to another system, when applicable. To minimize possible contamination, close upstream and downstream
dampers (if equipped). It is recommended that protective clothing, gloves, and respirators be worn when
changing filters with dangerous contaminants. Consult your safety officer before beginning filter change-
out to assure all proper procedures are followed for your application.
2. To gain access to the inside of the filtration housing, remove the housing access doorknobs by turning
counter-clockwise (for housings equipped with swivel latches: do not remove doorknobs; loosen and swivel
door bolt out from door corner retainer). Pull the access door straight towards you to remove.
3. To remove a prefilter, or header track filter, extend the change-out bag and follow steps 4 through 6. When
removing filters or adsorbers sealed by a locking mechanism, extend the change-out bag and release the
locking mechanism handle from the handle latch. Slowly open the locking mechanism by pulling the handle
fully open, this will pull the filter away from the knife-edge sealing surface. Upon completion follow steps 4
through 6.
FILTER CHANGE-OUT
(Replacing Contaminated Filters Or Adsorbers)
10