Divine Acoustics Kepler Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Divine Acoustics Kepler. Divine Acoustics Kepler 8 stron. Vibrations absorbing feet

Drukuj stronę

Keplers which are delivered in a set with Divine Acoustics speakers

permanently installed pins of appropriate length. After screwing them into the plinth and placing the

loudspeakers vertically, adjust the height with use of the adjusting ring "B". After setting the correct

height and leveling the loudspeaker, block the setting by screwing the nut "E" on top of the plinth.

Keplers with interchangeable pins screwed into a loudspeaker or plinth:

1. Screw in the threaded pin "C" with your fingers until you feel the resistance.

2. Tighten the counter nut "D" with your fingers.

3. Use the allen key "F" to hold the pin in a fixed position (do not fasten the pin with the key). Use

the flat key "E" - tighten the counter nut "D" - to block the possibility of turning the pin "C".

4. Screw the prepared Keplers into the speaker / plinth. Place the speaker vertically as shown in the

figure above.

5. Set the required speaker height and leveling with the adjustment ring "B".

6. Loosen the counter nuts "D" previously tighten with the "E" flat key.

CAUTION!

operation.

7. If you wish to change the height of the loudspeaker, tighten the counter nut again before

adjustment. Not blocking the nut may cause the pin to unscrew when the height is being adjusted.

5. Technical specifications:

•

outer diameter: 60mm;

•

weight of the foot: 247g;

•

minimum height (with nut): 35mm;

•

maximum height (with nut): depending on pin length - up to 43mm;

•

height of the screwing pins: 12mm, 20mm;

•

standard thread of pin: M8 or M6;

•

maximum load on one foot: 20kg

Leaving the "E" nuts tightened will result in incomplete Kepler anti-vibration

Designed and hand-build in Poland.

;

are equipped with