Alto-Shaam 1200-UP Series Instalacja, obsługa i konserwacja - Strona 8
Przeglądaj online lub pobierz pdf Instalacja, obsługa i konserwacja dla Podgrzewacz do żywności Alto-Shaam 1200-UP Series. Alto-Shaam 1200-UP Series 20 stron. 1200-up series low temperature hot holding cabinets
Również dla Alto-Shaam 1200-UP Series: Arkusz specyfikacji (2 strony), Podręcznik uzupełniający (4 strony), Broszura (4 strony), Arkusz specyfikacji (2 strony)
Drukuj stronę
E L E C t R I C a L C o n n E C t I o n
The appliance must be installed by a qualified
service technician. The oven must be properly
grounded in accordance with the National
Electrical Code and applicable local codes.
plug the unit into a properly grounded receptacle
ONLY, positioning the unit so that the plug is
easily accessible in case of an emergency. Arcing
will occur when connecting or disconnecting the
unit unless all controls are in the "
proper receptacle or outlet configuration or
permanent wiring for this unit must be installed
by a licensed electrician in accordance with
applicable local electrical codes.
d a n g E R
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code ANSI/
NFPA No. 70. In Canada, all electrical
connections are to be made in
accordance with CSA C22.1, Canadian
Electrical Code Part 1 or local codes.
I n S t a L L a t I o n
" position.
off
ELECt RICa L (
e a c h c o m p a r t m e n t
voltage
phase
cycle
230V
1
50/60
(
)
agcy
w I R E d I A g R A M S L O C A T E d I N S I d E b O N N E T
1200-UP MARInE • INSTALLATION/OPERATION/SERVICE MANUAL • 6.
For CE approved units:
To prevent an electrical shock hazard between
the appliance and other appliances or metal
parts in close vicinity, an equalization-bonding
stud is provided. An equalization bonding lead
must be connected to this stud and the other
appliances / metal parts to provide sufficient
protection against potential difference. The
terminal is marked with the following symbol.
notE: CE approved appliance must be
connected to an electrical circuit that is
protected by an external GFCI outlet.
Hard wired models:
Hard wired models must be equipped with a
country certified external allpole disconnection
switch with sufficient contact separation.
If a power cord is used for the connection of the
product an oil resistant cord like H05RN or H07RN
or equivalent must be used.
)
/
kW
hz
amps
cord
7.7
1.8
d a n g E R
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE.
d a n g E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
&
plug included
7/7,
cee
220-230
v plug
.