3DUpFitters Taz6 Enclosure Kit Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Drukarki 3D 3DUpFitters Taz6 Enclosure Kit. 3DUpFitters Taz6 Enclosure Kit 15 stron.

There are also mid-panel connectors on the top and left and right sides of the door

frame. These should be attached using M4 cap head 12mm screws.

3. Assemble Latch Mount

Locate the magnetic latch and use the wood

screws to attach it to the latch mount. Hand

tighten and ensure it's secure, but do not

overtighten, or the screws may strip. The latch

can be later adjusted front-to-back to ensure the

door is ﬂush with the door frame.

The assembled latch mount is attached to

the inside of the door frame via two M4

14mm cap head screws at the bottom of the

door frame, as shown to the right.