3DUpFitters Prusa i3 MK2 Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Obudowa 3DUpFitters Prusa i3 MK2. 3DUpFitters Prusa i3 MK2 18 stron. Enclosure kit
Również dla 3DUpFitters Prusa i3 MK2: Instrukcja instalacji (11 strony)

Drukuj stronę

Now that the latches are mounted it is time to

connect the strike plates. Each plate comes with a

squishy adhesive covering the same size of the

plate. Carefully attach the adhesive side to the

acrylic at the location of each latch. Then, adjust

the width of the metal strike plate so that it is held

on by the pressure of the two sides of the plate.

The adhesive covering will keep the strike plate

from scratching the acrylic.

You can adjust the way the door swings by using the magnetic latch to hold the left

side of the door in place, and then placing the front on its side so the hinges are at the

top and the latch at the bottom. Loosen the screws and adjust the position of the

hinges so that there's an even gap on all sides of the door. The door should open and

close freely.

When the front is ﬁnished it will look like the image to the right.

2. Attach Left Side

The left panel is distinguishable by its small hole

for a cable grommet, in addition to having "left

side" written on it. Insert the grommet as

pictured before attaching the front of the left-side

to the door frame. This is for connecting a USB

cable to the motherboard or to pass wires from

LEDs to a power strip.