Monitor Support
The following table lists each R1350 video option and the number of
supported monitors for each option.
Graphics Option
Intel® GMA 950 integrated graphics engine
NVIDIA® Quadro®4 PCI-Express® card
V5120 Dual Host card
Video Options and Ethernet Port Behavior
The R1350 provides two Ethernet ports that correspond to the primary and
secondary Ethernet jacks on a chassis. Your graphics card configuration
determines the behavior of the R1350 Ethernet ports.
•
V5120 Dual Host card—R1350 blades with V5120 graphics cards
enable you to connect to I9420 I/Ports or C7420 C/Ports through the
secondary Ethernet port. The primary port provides gigabit Ethernet.
•
Quadro4 PCI-Express card and GMA 950 integrated graphics—
R1350 blades using either of these graphics options provide two
independent network connections. The primary Ethernet controller
provides gigabit Ethernet. The secondary Ethernet provides 10/100
Ethernet. The dual Ethernet ports on the R1350 are accessible as
follows:
–
16-port EP6 module in R4300 chassis—All ports are available.
The primary ports on the blade are connected to the
corresponding primary ports on the EP6, and the secondary ports
on the blade are connected to the corresponding secondary ports
on the EP6. If Ethernet port availability in the data center is an
issue, connect to the primary Ethernet ports on the EP6 first.
–
R1350 installed in an R4200 chassis—Only the primary port on
the R1350 is connected.
WEEE Disposal Guidelines
In the European Union, this electronic
product falls under the European Directive
(2002/96/EC) WEEE. When it reaches the
end of its useful life or is no longer wanted,
it should not be discarded with conventional
waste, but disposed of at an approved
designated recycling and/or treatment
facility.
Laws are different in each country, so
please check with your local authorities for
proper disposal instructions.
For assistance, contact ClearCube at
RoHS
ClearCube Technology
Single
Dual
Quad
Monitor
Monitor
Monitor
X
X
X
X
X
X
8834 Capital of Texas Hwy N
Upgrading R1350 Memory
Only use memory that ClearCube supplies. R1350 blades support a single
DIMM and two DIMMs of different sizes and speeds. When you install
DIMMs of equal size, the R1350 memory controller uses interleaved
memory mode for better performance.
To replace or upgrade memory, perform the following steps:
1.
Pull the tabs on either side of the memory socket apart to remove the
memory module.
2.
Carefully insert the new memory module into the socket, making sure
that the tabs snap inward to secure the module. Always populate slot U5
(closest to the bottom of the blade) first.
Note: If DIMMs are equal in size but mismatched in speed or timing, the
blade runs at the slower of the two speeds. With mismatched DIMM
sizes, the system always runs in non-interleaved mode at the slower
speed or timing of the two DIMMs.
Populate Bottom Slot First
The R-Series Data Center Products Reference Guide contains more
information about the R1350 blade.
For more information, please contact ClearCube Technical Support.
Email:
Web site:
support.clearcube.com
Toll-free:
(866) 652-3400
Phone:
(512) 652-3400
Austin, Texas 78759
voice 512 652 3500 www.clearcube.com
DIMM Slots
G0200101 Rev A
Drukuj stronę