3DUpFitters Prusa i3 MK3S Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Obudowa 3DUpFitters Prusa i3 MK3S. 3DUpFitters Prusa i3 MK3S 18 stron. Enclosure kit
Również dla 3DUpFitters Prusa i3 MK3S: Instrukcja instalacji (11 strony)

Drukuj stronę

5. Attach Top

Before you tackle the top, now is a good time to

install the cross beam that adds support to the top

in case you want to put the spool holder on top.

(See beam circled in red in the illustration to the

right.) It should just slide into the slots as shown

before you attach the top. If you don't see slots at

the top one of the sides is probably on upside

down.

Note that until the top is connected security the

beam may fall out of place. That's ﬁne, just put it

back before tightening the mid-corner connectors.

With the beam in place, it's time to remove the

plastic. First lay the top on a ﬂat surface as

shown in the instruction video.

https://www.3dupﬁtters.com/blogs/news/acrylic

Be careful, as the area around the ﬁlament slit

will crack if handled roughly.

The top has a front, back, and left to right. This is

because it overhangs the front which is twice as

thick. The right side of the ﬁlament slit is closer to

the right edge than the left. Use access through the

doors to attach the top of the enclosure using M4

12mm screws.

If you attach the top and there's overhang in the

back, then it's attached backwards.