ClearCube C7422G Skrócona instrukcja obsługi
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przełącznik ClearCube C7422G. ClearCube C7422G 2 stron. Zero client
Drukuj stronęFront
PCoIP Session
Indicator
Client Power &
Indicator
Remote PC
Power
USB Port
Reader Activity
Indicator
Rear
Serial Number
MAC Address
USB Ports
DVI #1
DVI #2
HD Audio Out
Power Jack
Kensington Security Slot
ClearCube Technology
Quick Start Guide
C7422G Zero Client
HD Audio Out
HD Audio In
Connection
Status
SC Fiber
8834 Capital of Texas Hwy N
Austin, Texas 78759
Zero Client Overview
®
ClearCube
C7422G Zero Clients connect to supported
ClearCube PC blades and virtual machines containing V5x20
Dual Host cards to provide the following:
•
1 Gbps SC fiber
•
Support for up to two independently-configurable monitors
•
PC–over–IP™ (PCoIP™) processors, delivering PC video
and audio over an IP network
•
Four USB ports
•
HD audio in (front) and HD 4.0 audio out (one 1/8-inch mini
jack on front and one on rear)
ClearCube PC blades are typically located in remote data centers.
Each blade user has a C7422G Zero Client on their desk, which they
use to connect to a remote blade over an IP network (consisting of
fiber and Ethernet segments). Users connect monitors, pointing
devices, and other peripherals to their client, enabling them to work
on the blade as if it was a local PC. The connection between the zero
client and the blade is over PCoIP protocol. Inside the blade, a
V5x20 Dual Host card manages the PCoIP session on the blade.
Monitors
Multimode
Fiber
C7422G
Zero Client
Keyboard
Mouse
Client connected to blade with V5x20 card over fiber & Ethernet
NOTE:
You can enable a zero client to receive an IP address
from a DHCP server. If a DHCP server does not
assign an address within a designated timeout period,
the zero client uses a default, fallback IP address.
Starting with TERA firmware 3.3, this timeout period
has increased to 120 seconds. If you use these default
addresses and have DHCP enabled, you must wait
120 seconds before you can connect to a host. If you
use the direct connect methodology in your
environment, ClearCube recommends disabling the
client's DHCP setting to eliminate the need to wait 120
seconds before connecting. See PCoIP System User's
GUide at
support.clearcube.com
—Continued on Reverse—
voice 512 652 3500 www.clearcube.com
F6150 Fiber Transceiver
Ethernet
Network
Switch
Chassis and Blades
for more information.