3DUpFitters CR-10 S5 Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki 3DUpFitters CR-10 S5. 3DUpFitters CR-10 S5 15 stron. Enclosure kit
9. Sealing Gaps
Once the enclosure is completely put together, it is time to make sure that each of the panels is held
tightly to each adjoining panel. The connectors are designed with a small amount of play that allows you
to make small adjustments for the perfect fit.
1. Loosen screws on the panel to move.
2. Push that panel into place. You may need a friend to hold it tightly in the right spot.
3. Re-tighten the screws to hold the panel.
Repeat the product, going around the enclosure looking to make sure all of the panels are flush to each
other.
Accessories
Instructions for the spool holder are available online. You
can simply sit the spool holder on the top of the enclosure,
or optionally secure it to the side of the enclosure to keep it
from falling off the enclosure as the printer vibrates the
table.
Note the location of the spool holder is for the mostly stock
CR-10 extruder location. Those of you who have heavily
customized the hot end can feel free to drill holes and
move the spool holder where appropriate.
Of course, you are free to use whatever type of freestanding
spool holder you wish; there are hundreds of designs available on Thingiverse.
.
Filament Guide
The filament guide is also optional, but does make it easier for the filament to make the 90
degree change from the top into the horizontal extruder mechanism. This type of 90 degree
bend doesn't work with really brittle filament such as metal infused copper or bronze, and in
those cases you can simply bypass the guide altogether and send the filament directly into the
extruder.
Copyright 2019 3DUpfitters
12