ESI ESRTD3 Instrukcja obsługi i instalacji - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Termostat ESI ESRTD3. ESI ESRTD3 20 stron. Digital room thermostat with tpi & delayed start
Również dla ESI ESRTD3: Instrukcja instalacji (12 strony), Instrukcje użytkownika (8 strony)
Drukuj stronę
- 1. Table of Contents
- 2. What Is a Room Thermostat
- 3. What Is Chronoproportional Control (TPI)
- 4. What Is Delayed Start
- 5. Installation Instructions
- 6. Technical Data
- 7. Installation Safety Instructions
- 8. Maintenance
- 9. Safety Notice
- 10. Mounting the Thermostat
- 11. Wiring Diagram
- 12. DIP Switch Settings - Heating
- 13. Setting Delayed Start
Mounting The Thermostat
1. Position the Thermostat about 1.5m
above floor level, in a location where
the thermostat is accessible, reasona-
bly lit and free from extremes of
temperature and draughts. Do not
position the thermostat near sources
of heat, such as TV, radiators,lights,
direct sunlight or on an outside wall.
2. Loosen the screws on the back-plate and remove from the thermostat.
3. Fix the back-plate, terminals at the top, either directly onto a flat wall using
wall plugs and screws or on a flush mounting single conduit box. Route the wires
through the back of the thermostat and fit the wires to the wall-plate in accord-
ance with the relevant diagram shown overleaf and in accordance with I . E . E .
regulations.
4. Select personal options by referring to DIP switch menu (See page 10).
5. Fit the thermostat onto back-plate, and tighten the screws.
6. Ensure an appropriate fuse is fitted to the circuit before reconnecting to the
mains supply (3 Amp usually).
8