ESI DuaFire Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający ESI DuaFire. ESI DuaFire 20 stron. 2-in/4-out firewire recording interface

Drukuj stronę

DuaFire

ESI

2. Description of DuaFire

2.1 Front Panel

The front panel has the following connectors and controls from left to right:

Input 1: the first input channel is provided as balanced XLR input (MIC IN) for microphones and

1/4"-input (LINE IN) for line level signals. You can only use one of the two input connectors at a

time. The input level is controlled by the GAIN knob with peak LED next to it. Above the gain

knob is the +48V phantom power switch with LED that needs to be enabled if you are using a

condenser microphone. For a dynamic microphone, phantom power does not have to be enabled.

Input 2: the second input channel is provided with a 1/4" connector (LINE / HI-Z IN) that can be

used for line level signals or high impedance instrument signals (like a guitar). Next to it is the

GAIN knob to control the input level. With the HI-Z switch, you can switch between line level and

instrument / guitar signals.

Headphone Out: the HEADPHONE output with 1/4" connector and gain control is located on the

right side (directly under the POWER LED).

2.2 Rear Panel

The rear panel has the following connectors and controls from left to right:

Power Connector: even though DuaFire is bus-powered, it might be needed to connect an external

power supply (e.g. when DuaFire is connected to a PC with a 4-pin FireWire port). The power

supply gets connected to the DC IN port.

FireWire port: the FIREWIRE connector is used to connect DuaFire to the computer.