ESI EPPA2-KIT Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stojaki i stojaki ESI EPPA2-KIT. ESI EPPA2-KIT 12 stron. Dual monitor arm conversion

EPPA2-KIT

Install the Monitor Arm and Other Components onto the Dual Arm Base Assembly

• At the top of the dual arm base assembly, place the top bushing onto the protruding rim. Then insert the

monitor arm that you removed from the single arm base assembly.

• From the bottom of the base assembly, install the bottom bushing. If necessary, tap it down so that the

monitor arm stem protrudes slightly from the bushing.

• Fit the shaft washer over the stem, aligning the flat sides of the washer with the flat sides of the stem.

• Fit the curved washer over the socket head screw with its outer curve against the screw head. The

concave side of the washer will be against the shaft washer.

• Use the 6mm Allen key to fasten the socket head screw into the monitor arm stem.

— Securely tighten the screw.

• Check that the monitor arm can rotate without difficulty. If it cannot, check that you have installed all

re-used components correctly.

Parts to Re-Use:

Top Bushing

Bottom Bushing

Shaft Washer

Curved Washer

M7x16

Socket Head

Screw

Dual Arm

Base Assembly

MONITOR ARM INSTALLATION