dixell CoolMate XLR130C Instrukcje instalacji i obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcje instalacji i obsługi dla Kontroler dixell CoolMate XLR130C. dixell CoolMate XLR130C 20 stron. Cool mate

8.2 PANEL MOUNTING

Make a hole in the panel with dimensions described in Fig. 4 (simplified) or Fig. 5 (completed)

Unscrew the 4 frontal screws (Fig. 1, A, B, F, G) and remove the cover (Fig. 1, C).

Unscrew the 2 screws (Fig. 1, D, E) that keep connected the frontal and lower parts of Cool Mate and separate the 2 parts.

Cut from the back part of the Cool Mate the teeth indicated in Fig. 6, A.

Make the proper holes for cablepresses or pipepresses using the centres signed in the bottom cover of the Cool Mate, (Fig. 3, H, I, ).

Fix the cablepresses and the pipepresses..

Insert the wiring cables in cablepresses or in the pipepresses.

Join the back and frontal parts, with the panel in the middle, and fix them screwing the 4 screws taken previously away (dimensions 4x35

mm), in the holes of Fig. 1, A, B, D, E. Maximum panel thickness: 6mm.

After connecting the wires to the terminal blocks close the cover (Fig. 2, c) and fix it by the screws.

9. DIMENSIONS

10. ELECTRICAL CONNECTIONS

The instruments are provided with screw terminal block to connect cables with a cross section up to 2,5 mm

Before connecting cables make sure the power supply complies with the instrument's requirements. Separate the probe cables from the power

supply cables, from the outputs and the power connections. Do not exceed the maximum current allowed on each relay, in case of heavier loads use

a suitable external relay.

10.1 PROBE CONNECTIONS

The probes shall be mounted with the bulb upwards to prevent damages due to casual liquid infiltration. It is recommended to place the thermostat

probe away from air streams to correctly measure the average room temperature. Place the defrost termination probe among the evaporator fins in

the coldest place, where most ice is formed, far from heaters or from the warmest place during defrost, to prevent premature defrost termination.

11. TTL SERIAL LINE

Instruments of CoolMate series are provided with serial communication port that can be TTL or RS485 (optional).

The TTL connector allows, by means of the external module TTL/RS485, to connect the unit to a network line ModBUS-RTU compatible as the Dixell

monitoring system XJ500 l'XWEB3000, o l'XWEB300 (Dixell).

The same TTL connector is used to upload and download the parameter list of the "HOT KEY". These instruments can be ordered with direct serial

output RS485 (Optional).

12. HOW TO USE THE HOT KEY

12.1 HOW TO PROGRAM A HOT KEY FROM THE INSTRUMENT (UPLOAD)

Program one controller with the front keypad.

When the controller is ON, insert the "Hot key" and push o key; the "uPL" message appears followed a by flashing "End"

Push "SET" key and the End will stop flashing.

Turn OFF the instrument remove the "Hot Key", then turn it ON again.

NOTE: the "Err" message is displayed for failed programming. In this case push again o key if you want to restart the upload again or remove the

"Hot key" to abort the operation.

1592017000 XLR 130-170 GB r2.0 23.03.2015

210

XL130 - XLR170

. Heat-resistant cables have to be used.

15/20