ESI 2TD-C48-30-SLV Instrukcja montażu - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz ESI 2TD-C48-30-SLV. ESI 2TD-C48-30-SLV 12 stron.
Drukuj stronę
Trada 2-leg
Assembly
power
power cord
power supply
supply
holder
motor cable
power supply
cable
motor cable
handset cable
control unit
#6x
/
"
5
8
Phillips round head
handset
Step #9: attach handset
• Position the handset on either side of the table (user preference). NOTE: With the table face-down, the left side will be the right side when the table is turned upright.
• Position the handset so that the controls are flush with the front edge of the table.
• Attach the handset using two #6x
/
" Phillips round head screws.
5
8
Step #10: attach control unit
• Position the control unit in front of the front crossbar, approximately centered on the worksurface from side-to-side.
• Attach the control unit using the two #6x
/
" Phillips round head screws.
5
8
Step #11: attach power supply
• Fit the power supply into the power supply holder.
• When the table is turned upright, the power cord end should be the end closest to the nearest AC outlet.
Step #12: make cable and cord connections
• Connect the cable from the handset to the control unit.
• Connect the motor cables from the legs to the control unit.
• Connect the cable from the power supply to the control unit.
• Connect the power cord to the power supply.
• Plug the power cord into an AC outlet. Be sure the cord will be able to reach the outlet when the table is raised to its highest position.
CAUTION: Do not operate the table until after initializing the system. See the following step.
Page 8