ESI FLEX2-SLV Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wyposażenie wnętrz ESI FLEX2-SLV. ESI FLEX2-SLV 12 stron. Electric table base

ALL-FLEX

ELECTRIC TABLE BASE

™

Memory

Buttons

Button

GENERAL OPERATION

Move the table up or down by pressing UP s or DOWN t until

the work surface reaches the desired height.

The table will continue to move up or down until you release the

button or until the maximum or minimum height is reached.

IMPORTANT: Be sure there are no obstructions to table

movement along its full range of travel.

SETTING A MEMORY POSITION

The memory buttons allow you to save up to four specific

positions of the work surface. To set a memory position:

• Adjust the work surface to the position you want to save. (The

display on the control pad shows the work surface height.)

• Press the UP s button and one of the memory buttons at the

same time for 3 to 5 seconds.

• The display will flash "P" and the number of the memory

button.

• Repeat for the other memory buttons, if desired.

MOVING TO A MEMORY POSITION

• Press and hold the desired memory button.

• The work surface will move to the preset position.

Table

DOWN

Memory

Height

Button

Buttons

CAUTION: The "zero setting" procedure

must be completed before operating the

table. See Step 16 on page 8.

Table movement stops when you

release the UP s or DOWN t button.

Example: Press the UP s button and

memory button number 3 at the

same time for 3 to 5 seconds. The

display will flash "P3" indicating that

the current table position has been

saved in memory.

Continue to press the memory button

until table movement stops.

OPERATION