Alto-Shaam 1000-MR2-1 Instalacja, obsługa i konserwacja - Strona 15
Przeglądaj online lub pobierz pdf Instalacja, obsługa i konserwacja dla Lodówka Alto-Shaam 1000-MR2-1. Alto-Shaam 1000-MR2-1 19 stron.
Drukuj stronęInterIor cleanIng
Open the refrigerated cart door to warm the
interior of the cabinet.
1. Remove any loose food debris with a cleaning
cloth or small hand broom.
2. Use a mild, non-abrasive detergent and warm
water. Wipe-down the interior of the cabinet,
removing all food residue. This includes the
ceiling, floor, and walls.
Wipe-down the interior door panel and clean
the vinyl gaskets. Make certain to clean under
the gaskets to remove any mildew accumulation
or food residue.
3. Rinse all interior surfaces including the cabinet
door and gasket with clean water and a cloth.
Remove all rinse water.
4. Wipe interior surfaces with a clean cloth and
sanitizing solution for use on metal and vinyl
food contact surfaces. This is an important step
to control the build-up of unwanted mildew
and mold in the refrigeration system.
5. Allow interior to air dry with door open.
exterIor cleanIng
1. Wipe all exterior surfaces
including the control panel,
door frame, latches, and hinges
with a damp cloth containing
a mild, non-abrasive, non-
chloride detergent solution.
2. Rinse detergent solution with a cloth and
warm water. Allow exterior to air dry.
3. Polish with any standard stainless steel polish
designed for use on food service equipment.
When cleaning the exterior of the cabinet,
always wipe with the grain of the stainless steel
to avoid scratching or marring the finish.
Do not USE ABrASIvE CLEAnIng
C o mP oU n D S or Im P L E mE n t S .
w a r n I n g
To prevent SERIOUS INJURY,
DEATH, OR PROPERTY DAMAGE,
ALWAYS disconnect unit from power
source before cleaning or servicing.
c a r e a n d c l e a n I n g
MN-36246 (Rev. 1) 09/15 • MR2-1 Mobile Refrigerated Cart • 13
t I t l e
condenser cleanIng
All the heat removed from the cabinet is
discharged into the room via the condenser which
is similar to a car radiator. This must be kept
clean so that the air can pass through it to remove
the heat, if it becomes choked with dust the unit
will over heat and this can lead to a burnt out
compressor. The condenser should be brushed
with a soft brush to remove any dust deposited
on the alloy fins. The frequency of this cleaning
is determined by the amount of dust in the
surrounding area but should be cleaned at least 4
times a year.
gasKet replaceMent
Damaged gaskets can easily be replaced. Remove
the old gasket by gently pulling it out of the gasket
retainer and simply push in the new gasket leaving
the corners to last.
d a n g e r
To prevent SERIOUS PERSONAL
INJURY, DEATH, or PROPERTY
DAMAGE:
DO NOT steam clean, hose down
or flood the interior or exterior
with water or liquid solution of
any kind. DO NOT use water jet
to clean.
Failure to observe this precaution
will void the warranty.