ALTONOVUS NanoRanger Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe ALTONOVUS NanoRanger. ALTONOVUS NanoRanger 2 stron. Auto-ranging dc ammeter

Drukuj stronę

NANORANGER - BASIC MENU FUNCTIONS

•

Measure (as described on the previous page).

•

Range Maximum.

•

Range Minimum.

•

Measure Average.

•

Advanced.

MEASURE AVERAGE - Use this function to calculate an average

current over a time period, within a single range. Having prevented

auto-ranging (Set Range Max and Min), press Select to begin, and the

first screen below will be shown. Press Select again to end the meas-

uring period. At the end of the period, the second screen shows:

USING THE FULLY ISOLATED USB INTERFACE

NanoRanger's micro-USB interface can be used to export readings

and to control the device via a PC (SCPI-format). The USB interface

cannot

be used to power NanoRanger, as it is isolated from the main

circuitry to prevent interference. For help connecting NanoRanger,

see the guidance in our website's NanoRanger section. For SCPI

instructions, please download the full NR-01 Instruction Manual at:

www.altonovus.com

USE IN CONJUNCTION WITH THE FULL INSTRUCTION MANUAL. DOWNLOAD AT:

Press the Menu button to exit

measuring and enter the Menu mode.

This screen will appear. Use the

Navigate and Select buttons to move

through the Menu. The options are:

RANGE MAXIMUM / MINIMUM - Use

upper

these options to set the

limits over which NanoRanger will

Auto-Range during operation.

If not constrained by the User,

NanoRanger will exploit it's full

measurement range.

The screen may show "UNDER LOAD" if

a minimum range has been set, or if

nothing is connected to NanoRanger.

•

The average current over the period

(here 910.0uA).

•

The sample time, shown in multiples

of 200mS.

•

The total charge for the period (here

1.668uAh).

•

The highest (Sh) and lowest (Sl)

samples taken in the period.

ADVANCED MENU FUNCTIONS -

In this element of the Menu, the User

can configure the Auto-Powerdown

timer and LCD back-Light.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the User is encouraged to try to correct the interference by one or more of

the following measures:

- Reorient or relocate the receiving antenna.

lower

and

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different that to

which the receiver is connected.

- Consult the dealer, or an experienced radio/TV technician for help.

MODEL: NR-01: AUTO-RANGING DC AMMETER-

QUICK START GUIDE