ClearSounds CL-3108 Podręcznik użytkownika - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Telefon bezprzewodowy ClearSounds CL-3108. ClearSounds CL-3108 16 stron.

Drukuj stronę

Handset Settings

Handset registration

1. Make sure the base unit is connected into the AC outlet and line

jack.

2. Press and hold the

button on the base unit. After 3 seconds,

press the

button on the handset, the unit will give you a

confirmation beep, which means that the code has been set and the

handset will show

on the LCD.

HS -1

3. If you have a second handset need to be registered to the same

base, press the

button on the handset until you get a beep and

the display shows

HS -2

. Continue the same procedure, if you have a

third handset. If not, release the

NOTE:

The

button on the base unit should be kept pressing

during the whole procedure.

IMPORTANT NOTICE:

The base unit and the handset have been set

code already.

Settings

In standby mode, press

SEL

to indicate you enter the setting mode.

PROGRAM

button from the base unit.

button once, then the LCD will show

EFORE SING

Out of range warning

In talk mode, if the handset is too far away from base unit, an out of

range warning tone will be heard. The user should move closer to the

base unit. If not, the handset will automatically return to standby mode

after about 20 seconds. When the handset makes a noise, press

ton to return to standby mode.

Line transfer

If extra handsets are set to the base unit:

1. During a phone conversation, press

The line will be hold and make music sounds to the other end, both the

two handsets will ring.

2. The other handset can press

automatically after receiving the transfer ring.

3. Press

button to cancel the transfer if the other handset user does

not want to answer the call during the transfer ring.

4. If the two handsets do not respond within 40 seconds, the line will be

disconnected automatically.

Paging

1. Press the

button to page the handset.

2. Press

button once more to cancel the paging operation.

3. If you do not press

button again, the handset will ring for about

25 seconds then end the paging automatically.

SEL

button and handset number.

button to answer the call

ASIC UNCTION

but-