AltoShaam MARINE 100-HSL/BCS-2S Instrukcja obsługi i konserwacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprzęt do gotowania AltoShaam MARINE 100-HSL/BCS-2S. AltoShaam MARINE 100-HSL/BCS-2S 17 stron. Hot carving shelf
Drukuj stronę
ELECTRICAL INSTALLATION
1. An identification tag is permanently mounted on
the appliance.
SAMPLE
®
2. Plug appliance into a properly grounded
receptacle ONLY, positioning the unit so the
power supply cord is easily accessible in case of
an emergency.
3. If necessary, a proper receptacle or outlet
configuration as required for this unit, must be
installed by a licensed electrician in accordance
with applicable, local electrical codes.
For 230V units: To prevent an electrical shock
hazard between the appliance and other
appliances or metal parts in close vicinity, an
equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances / metal parts
to provide sufficient protection against potential
difference. The terminal is marked with the
following symbol.
NOTE: The appliance must be connected to an
electrical circuit that is protected by an
external GFCI outlet.
HEATING CHARACTERISTICS
The shelf is equipped with a special, low-heat-
density, heating cable. Through the Halo Heat
concept, the heating cable is mounted against the
top surface of the shelf to provide an evenly applied
heat source, controlled by a
Through even heat application, the quality of
a food product is maintained up to as much as
several hours.
I N S TA L L AT I O N
PH
3521030
PATENT NOS.
4595247
thermostat.P
O & C M A N U A L • M A R I N E H O T C A R V I N G S H E L F
P G . 4
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70.
In Canada, all
electrical connections are to be made
in accordance with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.