ClearSpan Storage Master Solarguard Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Namiot ClearSpan Storage Master Solarguard. ClearSpan Storage Master Solarguard 20 stron. Poly shelter round “hut” style 30' wide x 15' high x 48' long
Drukuj stronę
Section F - Installing Struts
After the frame is square and secure, and the rafters are plumb, install the diagonal struts. The
struts keep the frame stabilized by preventing it from rocking forward and backward. You will use
conduit pipe to construct the struts.
Step 1: Assemble four 14' struts using (2) 6' pieces of swaged conduit and a 2' plain piece each.
Secure the joints with a Tek screw.
Step 2: Attach one end of the strut to an end or outside rafter, approximately 7' above the ground,
using a pipe strap and 2 Tek screws. Make sure the end of the pipe is flush with the strap and
tighten the screws.
Step 3: Attach the other end of the strut to the fourth rafter directly above the lowest purlin with a
pipe strap and 2 Tek screws positioning the strap 1" in from the end of the strut (so the pipe
sticks out of the strap 1"). Do not tighten the Tek screws yet so the strut can slide if necessary.
Step 4: After the pipe is angled in place, apply pipe straps and Tek screws to the other two rafters in
between.
Tip: When angling each strut, have someone help hold it in place or use heavy tape. Also, a
slight bend will be required in the strut for proper alignment. This procedure is best done by
two people. Have one person apply the necessary pressure to hold the pipe against the rafter,
while another applies the strap and screws.
See the illustration below showing the struts installed:
Note: All rafters are not shown in this illustration - Just the first 4 at the right end
Page 14