ClearSpan Pro Solar Star Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Zestaw do szklarni ClearSpan Pro Solar Star. ClearSpan Pro Solar Star 15 stron. Greenhouse door kits

ASSeMbLING THe DooR FRAMe CoMPoNeNTS
Consult the diagrams at the back of these instructions before you begin.
Assistance is required to assemble the door frame.
INSTALL THE DooR JAMBS
The following steps describe one way to set the door jambs.
1.
Using the dimensions from the
Quick Start section, locate and mark the positions of the door jambs.
2.
Dig a 10"-12" diameter hole at the locations found in previous step to
a depth that is below the geographic frost line. (Minimum depth: 24".)
3.
Locate the 120" door jambs (105488120). Using a metal saw, cut and
remove the 2-1/2" sections from one end of each door jamb as shown
in photo A. This creates a lip and allows the jamb to be attached to the
girt (see photo B and C).
ATTeNTIoN: Diagrams A-D show the left door jamb only. Adjust cuts
when cutting the end for the right jamb.
4.
Using the diagrams as a guide, attach each jamb to the girts using
108553 wafer head screws as shown in photo C, D, and E. (Install
end wall girts if needed.)
ATTeNTIoN: Position the door jambs so the open sides of the
C-channel face away from the door opening (as shown in the photo
C) and the lip overlaps the girt. When attached to the girt, the lower
end of each jamb extends into a ground anchor hole and is secured in
place using concrete. Consult a knowledgeable contractor if needed.
When installing the lower girts (if needed) of the end wall, verify that
the inside-to-inside dimension for the door frame remains consistent.
End wall as seen
from the outside.
If you are installing end
wall framing, install the
two lower girts after door
frame (see X).
X
105488120
Door Jamb
X
Revision date: 05.28.10

Door Frame Assembly

Door Frame Layout located in the
C
96-1/2"
(inside-to-inside)
D
96-1/2"
Ground Level
A
2-1/2" Lip
b
108553
Wafer Head
Screws
C
D
105488120
Door Jamb
e
X
X
e
e
Cut along
dotted lines.
Remove
this section
2-1/2"
2-1/2"
Left Jamb
Toward
Door
Front
opening
Wafer Head
Screws
Left
Jamb
Wafer Head
Screws
Front
Right Jamb
5