Dixon Bayco FT300 Series Instrukcja konserwacji i obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja konserwacji i obsługi dla Kable i złącza Dixon Bayco FT300 Series. Dixon Bayco FT300 Series 5 stron.

FT300 SERIES TRAILER MOUNTED SOCKETS

WIRING INSTRUCTIONS:

When wiring the sockets to an onboard monitor it is highly recommended using FloTech FT401

jacketed 5-conductor cable when wiring a new system. FloTech cable is designed to be oil, UV,

and abrasion resistant. We incorporate a noble tin plated stranded copper wire which resists

corrosion. These features will provide years of reliable service.

After all sensors are mounted in each compartment, align the conduit openings so they face the

roll over rail. Thread in cable glands and pull a length of cable through the conduit openings

between each sensor. Cut to length leaving approximately 8 inches extra length exiting the top

of each probe holder.

FOR SOCKETS USING NPT SIDE OPENINGS:

All socket cables must enter or leave through one of the ½ NPT openings. Use FloTech FT402

½ NPT cable glands to ensure a water tight seal. Unused conduit openings must have a ½ NPT

pipe plug installed. Use pipe dope on all ½ NPT threads to ensure a water tight seal.

FOR EUROPEAN SOCKETS USING METRIC M20 X 1.5 SIDE OPENINGS:

All socket cables must enter or leave through one of the M20 X 1.5 threaded openings. Use

FloTech FT402E M20 X 1.5 cable glands with thread sealant to ensure a water tight seal.

Unused conduit openings must have a M20 X 1.5 plug with o-ring installed.

Wire the sockets according to diagram 2 below. Double check your wiring connection when

complete. NOTE: It is highly recommended to use a small amount of Silicone RTV sealant in

each crimp connection. Fill the FloTech butt end crimps with Silicone RTV sealant prior to

inserting the wires then crimp. This will provide a watertight and vibration resistant

connection.

When wiring is complete, replace each sensor cap and o-ring. CAUTION: Do not pinch a sensor

wire when installing the cap.

For Technical Assistance Call 877 582 3569

877.582.3569

10158 REV F 2016/08/31