ClearSpan R024B00008 Podręcznik - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik dla Zestaw do szklarni ClearSpan R024B00008. ClearSpan R024B00008 13 stron. Twin-wall polycarbonate end panel kit 20' wide & 24' wide
Drukuj stronęEND PANEL INSTALLATION (continued)
14.
Repeat steps to install the next panel. Work from the center
outward to install the remaining panels.
15.
Finish the end wall using two (2) 6' x 10' panels on the
outer position of the end wall. Measure, cut, and install
panels as previously described. Cut the outer 6' x 10'
panels so each is flush with the side wall hat channel and
installed side panels (if equipped) of the main building.
NOTE: Do not allow the edges of the two outer end wall
panels to extend beyond the edge of the side wall hat
channel and installed sidewall panels (if present). When
sidewall panels are present, the panels of the end wall and
sidewall meet to form a finished edge at each corner of the
building.
16.
Measure and cut a section of 104213 profile and install it
along the outside edge of each outer panel to complete
installation (see drawing C).
17.
Install a Tek screw to secure the H-channel to the frame in
each place where H-channel crosses the end wall brace.
See letter D in the diagram below for an example.
18.
Continue by reading the care and maintenance section.
Panel pattern may vary. Refer to the panel
diagrams located in the Quick Start section
for the layout of panels for your end wall.
Trim
excess panel
104213
6' x 10'
Panel
Outer Panel
8
End Panel Installation
Trim
excess panel
Trim
excess panel
4' x 8'
Panel
D
4' x 12'
4' x 8'
Panel
Panel
D
D
GROUND LEVEL
End
Panel
Actual frame may differ from frame shown above.
Trim
excess panel
Trim
excess panel
4' x 8'
Panel
4' x 8'
4' x 12'
Panel
Panel
Outer End Wall
Panel
104213
Sidewall Hat
Channel
104213
24' Wide End Wall
Trim
excess panel
D
104213
C
6' x 10'
Panel
D
Outer Panel
D
Revision date: 08.22.13
C