DIY BT-104GSM Instrukcja instalacji i obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla System bezpieczeństwa DIY BT-104GSM. DIY BT-104GSM 8 stron. Business/home gsm alarm systems
Drukuj stronęHow to add new sensors.
If needs to add sensors as PIR detector, wireless door sensor, remote controller and so on :
1) The detectors of external zones: Powered the host, press the RESET key for 2 seconds, the
light becomes red. Then trigger the sensors, the wireless signal of the host will flash one time for
confirm. After 20 seconds, the alarm system turns into normal working automatically (green /
orange lights flashing)
2) The detectors of inner zones : First power the host, press the RESET key for 2 seconds, the
light becomes red ,then press the RESET key again, when the light changes from red to orange ,
trigger the sensors, the wireless signal of the host will flash one time for confirm. After 20
seconds, the alarm system turns to normal working
flashing)
If there are 3 detectors stored, represent wireless zones 1-3, if you add a new detector, this detector
represents zone 4.
Note: for the kits,door/window gap sensor is for external zone,PIR for inner zone .
If press Out Arm key, the detectors of external and inner zones will be in arming status.
If press Home Arm key, only the detectors of external zones will be in arming status.
How to delete the lost sensors
If the host needs to delete sensors in wireless zones (FIR detector,wireless door sensor,remote
controller and so on) :
Sending SMS: password # numbers（50-65）# ＊＊,will delete the sensors in this zones, the zone is
empty. Then the new sensors can be stored in this zone.
Resetting: After reset, all settings come back to original status, the original password is 123456 , the
other detectors must be stored in the host according to the above method, the first stored one takes
the first zone, other detectors are the same, the maximum number of zone is 16.
How to control the host with remote controller?
Disarm
rm
Home A
The remote controller has 4 keys: Out Arm, Home Arm , Disarm, Alarm
When press Out Arm, the light STATUS becomes orange flashing slowly, waiting for the arming
status, after 10 seconds the light becomes green flashing slowly, means the arming is successful. If
wireless detectors or wired ports triggered (all the wireless detectors are effective), then dial out phone
or send message, the light STATUS becomes red flashing.
When press Home Arm, the light STATUS becomes orange flashing fast, waiting for the arming
status, after 10 seconds the light becomes green flashing fast means the arming is successful. If
Out Arm
Alarm
automatically (green / orange lights