Edgewater Networks 200AE1 Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Gateway Edgewater Networks 200AE1. Edgewater Networks 200AE1 6 stron. Network services gateway 200 series
Drukuj stronęStep 1 − Connecting the Cables
1. Connect one end of an Ethernet cable to local LAN port 4 of the 200AE1 denoted by "E"
in the below diagram. Connect the other end of the cable to your computer's Ethernet
port.
Make sure that the LED in the top right corner is solid green. This LED indicates that the
link is up.
2. If you are using an ADSL connection, connect one end of the phone cable to the ADSL
port (denoted by "B" in the below diagram) and the other end of the cable to the phone
jack on the wall.
3. If you are using an Ethernet connection, connect one end of the Ethernet cable to the
Ethernet WAN port (denoted by "F" in the below diagram) and the other end of the
Ethernet cable to an Ethernet port on a router or a modem.
4. Plug one end of the power adapter into an AC outlet and the other end into the power
receptacle on 200AE1, denoted by "A" in the below diagram.
Make sure that the power and status LEDs denoted by "A" and "B" in the diagram below
are solid green after a short while.
Instructions
Page 2 of 6