DIYElectronics PRUSA I3 Podręcznik budowy - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik budowy dla Drukarki 3D DIYElectronics PRUSA I3. DIYElectronics PRUSA I3 19 stron.

[7.1] Filament Feeder Assembly

• Lay roof panel upside down

• Place smaller and bigger

filament feeder pieces on the

inside of the roof panel

*Line up holes as seen in picture

• Screw in M3x10 screws,

tighten with M3 nuts

(from the outside)

• Place roof panel on top of the

enclosure

• Secure with M5x16 screws

on all sides

*leave these screws a little loose

until right at the end

[7.2] Handles

• Place handles on top of roof

panel

• Use washers and M5x30

screws to secure