ClearWater AQUA ELITE 50 Instrukcja instalacji i obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Sprzęt oświetleniowy ClearWater AQUA ELITE 50. ClearWater AQUA ELITE 50 20 stron.

Drukuj stronę

C). TOOLS AND MATERIAL REQUIRED

The Aqua Elite 50 Clearwater Pool Systems unit should be installed at the pool's pump and filter area.

You will need to locate a place to mount the Aqua Elite 50 control box on a wall and within 10 feet or so of

where you will install the electrode chamber, within 6 feet of an electrical source and within 8 feet of the

Venturi Injector.

Power Source/

TimerBox

Venturi Injector

E). INSTALLING THE ELECTRODE FLOW CELL TEE

1.) Locate a space for the electrode flow cell tee (the 2" slip/slip/threaded tee). The tee should

be installed after the pump and either before or after the filter. After the filter is preferred, but it

will work fine if installed before the filter. NEVER INSTALL THE TEE NEXT TO THE

POOL'S HEATER.

2.) Turn off the pump and close all valves. Disconnect all sources of power going to the timer

or pump.

3.) Using a hacksaw or backsaw, cut a 4-inch gap in the section of pipe if 1 1/2" pipe exists, or

cut out a 3" gap if a 2-inch pipe exists.

4.) Sand the burrs off the pipe. Dry the pipe and clean the ends with PVC primer/cleaner.

5.) If 1 1/2" pipe exists, cement the 2" to 1 1/2" reducer bushings into the tee (included with the unit).

6.) The tee should be mounted on the return line after the pump and mounted slightly downward so that no air-pocket

can form in the electrode chamber (below a horizontal position). THIS IS EXTREMELY IMPORTANT. If there is

not enough "give" to allow insertion of the tee, install unions.

• Channel lock pliers

• Utility knife

• Crescent wrench

• Screwdriver, Flat and Phillips • PVC cleaner/primer

• PVC cement

D). SITE SURVEY

within 6 feet

within 8 feet

• Hacksaw or backsaw

• Hammer

• Teflon tape

• Wire stripper

AE-50 Power box

• Screws & anchors

• Drill & drill bit

• Flexible conduit

• Voltage meter

• Bullet level

within 10 feet

Electrode