Acoustics M20 HD Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Acoustics M20 HD. Acoustics M20 HD 14 stron. Wireless system

Drukuj stronę

Connecting between the speakers

Firstly, connect the supplied speaker cable

between the two speakers. The wires are

coloured differently to identify

and - polarity.

Ensure you always use the gold wire for

and silver wire for

at both ends.

Speaker positioning and assembly

Simply place the speakers either side of the

main listening position on an appropriate flat

surface, ideally about 2.0

4.0m (2-4 yards)

apart.

Alternatively you can use

M 20 with the

3000FSi floor stand or

3000WB wall bracket

(available separately), follow the instructions

supplied with these.

• The amplified speaker can be placed in

either the right or left position, simply set

the left/right switch correctly. The switch

sets left or right channel for the amplified

speaker.

Adjusting the EQ switch

• You can adjust the bass response of the

speakers to suit your desired bass level

which is affected by the speaker position

in relation to a wall, shelf, or

corner.

Try

listening to your M 20 speakers in each of

the three positions, selecting the one that

you are most happy with.

■

This position will give the most bass

output and is

suited

if the speakers are

placed away from walls or corners.

■

This position will give

mid-point in bass

output and is suited if the speakers are

placed close to

wall or on

shelf.

This position will give the least level of

bass output and is suited if the speakers

are placed in corners of the room.

Optional subwoofer

A subwoofer may be connected to the SUB

outlet as an option. The subwoofer should

include level and crossover controls. With the

subwoofer connected, play some music with

good bass content and adjust the subwoofei'

controls for the sound you prefer.

Port damping

The

M 20 speakers are rear ported and

designed to work best with some space

behind them i.e. 200mm or so away from a

wall. If you position your speakers close to a

wall

corner then the foam bungs should be

inserted

into the rear ports or there could be

too much bass.

• Ensure the bungs

are

fitted

snugly

into the port without

inserting them too

far.

You will find the level of bass is reduced but

definition and bass extension is increased.

Experiment to see what you prefer and try

making small changes to the position of

the speaker to optimise the final result.

Powering on

• Connect the power cable to the amplified

speaker and plug into a mains outlet.

Once powered up the standby LED will be

on red.

• To switch the system on, press C on the

remote or the control panel.

• To set the system to standby, press Con

the remote or long press C on the control

panel.

Auto standby

The

M 20 system includes an energy

saving auto standby feature. If no music has

played for twenty minutes the system will

automatically set to Standby.