Clearwater Enviro Technologies SCALEBLASTER AG-300 Instrukcja instalacji i obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy kontroli Clearwater Enviro Technologies SCALEBLASTER AG-300. Clearwater Enviro Technologies SCALEBLASTER AG-300 8 stron. Electronic lime scale control system for agriculture applications
Drukuj stronęF.) Powering up the Control Box / Computer
1.) The unit will work automatically on either 115 or 230 VAC, however the unit has a 115
VAC power plug on the end. You may simply plug this into a 115VAC outlet. Since
electrical outlets vary worldwide, or if you need 230VAC, the power cord plug may not
match your outlet type. In this case, it must be replaced with the proper plug by a
licensed electrician.
2.) Plug the power cord into the outlet.
3.) The unit should stay on 24 hours a day.
4.) Monitor the LCD screen from time to time to be sure of continuous operation.
The LED light on the front panel (far right) should light up on the AG-100 & AG-200
after being plugged in.
Operation of the AG-100 & AG-200 system can be confirmed by observing the
illumination of the LED indicator located on the face of the power unit. Power on - green
light on far right side will stay lit (Figure A). When pipe is wrapped and unit is turned on
the far right light will stay lit and the other lights will oscillate back and forth (Figure B).
This screen to the right will appear if the internal temperature reaches 180 degrees
Fahrenheit. At this point the unit will shut down until the temperature subsides. This
can happen if you inadvertently short out the coil output for extended periods of time or
mount the unit in direct sunlight. NOTE: AG-300 and AG-400 ONLY
G.) LCD Indicator Screen
OPERATIONAL
The Scanning Frequency Screen to the left indicates the unit is functioning correctly and is
sweeping the full frequency range of the calcium resonance. When the AG-300 and AG-400
are operating normally they will alternate between the two screens shown.
The screen to the right will intermittently show the
coil output status in percent and the internal system
temperature. NOTE: AG-300 and AG-400 ONLY
ERROR MODE
If there is an error (or the coil just isn't yet attached) the screen to the left will appear.
If the coil is connected and the message to the left is present, then contact your dealer
or Clearwater Enviro Tech for help. (AG-300 & AG-400)
Manufactured by
8767 115th Ave. N. • Largo, FL 33773
Phone: 800-756-7946 or 727-562-5186 • Fax: 727-562-5187
clearwaterenviro.com
Figure A
Power
Signal
Indicator
Indicators
Figure B
MADE IN THE U.S.A.