ClearWater Lights Dixie Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria motocyklowe ClearWater Lights Dixie. ClearWater Lights Dixie 12 stron. Led light kit dimmable
Drukuj stronę
Step 3: Mounting The Volume Control Knob
There are three ways to mount the volume control knob: 1) attaching it to the
handlebars with the provided M5x30mm screw and #7 spacer (most BMW's), 2)
drilling a hole in the fairing, or 3) mounting to a handlebar clamp.
*NOTE* The hardware for options 2 & 3 are only available upon request
Mounting Volume Control Knob Bracket:
(M5x30mm Screw Mount)
• Mount the volume control knob to handlebar by using supplied bracket,
spacer and bolt. (Fig. 1)
• Try to route wires from lights and volume control knob along pre-existing
wires. Make connections in a waterproof area.
Fig. 1
Fig. 1
Mounting Volume Control Knob Bracket: (Fairing Mount)
•
Mount the volume control knob in fairing by drilling a 5/16" hole and
mounting control with attachment nut. (Fig. 2)
• Check for minimum 2" clearance behind panel to allow for circuit board
and wire.
• Double check the fit of parts before drilling your panel. Measure twice,
drill once.
• Tighten nut (be sure not to over tighten and Install rubber knob over
volume control knob with press fit.
Mounting Volume Control Knob Bracket:
(Handle Bar Clamp)
• Mount the volume control knob to
handlebar by using supplied bracket,
bolt and clamp.
• Hint for High Vibration installations: To keep the Volume Control Knob from
rotating itself under high vibration, put a dab of silicone adhesive under the knob
and let it dry. Then push the rubber knob back on. The friction of the glue under
the knob will keep it in place.
Page 4
Page 5