ClearWater Lights Glenda Instrukcja instalacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt oświetleniowy ClearWater Lights Glenda. ClearWater Lights Glenda 12 stron. Led light kit for bmw k1600gt
Również dla ClearWater Lights Glenda: Instrukcja instalacji (12 strony), Instrukcja instalacji (12 strony), Instrukcja instalacji (12 strony), Instrukcja instalacji (16 strony)
Drukuj stronęStep 4: Wiring
Wire Routing:
• Be sure to route wires so that they cannot become tangled or caught
in either a suspension part or steering part. Check movement of both
steering and suspension before riding the bike.
• It is sometimes helpful to follow existing wire routing.
Wiring:
• Main power needs to be connected to a switched hot. This means one
that turns off with the key. An Auxiliary hot can be used as an alternative.
Using the supplied Posi-twist connectors, connect the wires according
to the accompanying color wire diagram. Attach ground lug to ground
on frame tab or other suitable location. Be sure not use a Low beam
headlight wire on H4 headlight bikes or else the lights will shut off when
the high beam is activated.
• Find a good solid ground point for the black wire terminal ring.
• Use a Posi-twist to connect the green wire from the volume control knob
to the two green wires from the lights (3 wires).
• Use a Posi-twist to connect red wire from the fuse holder to the red
wires from lights and volume control knob (4 wires)
• Connect ground/black wire to black wires from lights and volume control
knob. (4 wires)
• If you would like to use the high beam feature (recommended), use a
Posi-tap to connect the white wire from the volume control knob to the
High Beam headlight hot lead (+). This will be on only when the high
beam is illuminated.
Page 8
Page 9