EDIATec ECW100 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla GPS EDIATec ECW100. EDIATec ECW100 15 stron. Collision warning unit
Również dla EDIATec ECW100: Instrukcja instalacji (14 strony)

Drukuj stronę
EDIATec ECW100 Instrukcja obsługi

3. General Advice on Operation

This Manual must be carried on board the aircraft. When permanently installed in an
aircraft, the "AFM Supplement" must also be carried in the aircraft.
http://www.ediatec.ch/pdf/flarm_afms_v1.00stamped_en.pdf
In flight the pilot must have direct sight of and immediate access to a switch or circuit
breaker that disconnects ECW100 from the aircraft electrical power supply, without af-
fecting other essential aircraft systems. This might be necessary if the pilot suspects that
ECW100 may be interfering with another on-board system, the suspected presence of
smoke, the smell of smoke, or flying in a country where the use of ECW100 is not per-
mitted.
ECW100 must not be operated at night or with night vision systems.
ECW100 will not operate without adequate GPS signal strength. Correct antenna installa-
tion has a great effect on the transmission/receiving range.
Installation and operation must be on the basis of non-interference with and no hazard to
the existing suite of other certified equipment necessary for safe flying operation, or
installed to comply with official requirements. Installation and operation must comply
with official regulations and requirements. It is recommended that the ECW100, GPS and
radio antennae are all installed as far away as practicable — but at least 25 cm from —
susceptible aircraft systems such as GPS antennae and the magnetic compass.
The unit must be protected from solid particles or liquids, should not be exposed in use
to temperatures below –10°C or above +60°C, or stored at temperatures –20°C or above
+70°C, because this may cause irreparable damage. On the ground, the unit should be
protected from exposure to long periods of direct sunlight, because it is likely to be over-
heated.
Details on correct installation will be found in the Installation Manual.
Do not override the written limitations in operation and installation manual. Otherwise
the warranty expires.
Page 4