Edic ENDEAVOR Skrócone instrukcje obsługi - Strona 11

Przeglądaj online lub pobierz pdf Skrócone instrukcje obsługi dla Ultradźwiękowy środek do czyszczenia biżuterii Edic ENDEAVOR. Edic ENDEAVOR 15 stron. Multi-purpose extractor
Również dla Edic ENDEAVOR: Podręcznik właściciela/operatora (17 strony)

Drukuj stronę
HEATER:
The Endeavor model 9000I-HSH has been outfitted with an internal in-line 2000 watt dual element heater that
will provide consistent heat at 500PSI and below. The heater is controlled by a sensor that prevents it from
being turned on while the pump is spraying at high pressure. When the pressure is dropped to 500PSI and
below, the sensor will allow the heater to turn on.
Before turning the heater on, turn on your pump and make sure to spray for a
few seconds to evacuate any air from the system. Do not run the heater while
dry.
TO USE THE HEATER:
1. Turn the heater switch to the ON position. The green light on the heater switch will
light up if you are at 500PSI or below. If it lights up, skip steps 2 and 3 and move on
to step 4.
2. If you have been using the machine at any PSI above 500PSI, you must first drop
the pressure to below 500PSI before you can use the heater.
3. Turn on the pump and turn the regulator counter-clockwise. Drop the pressure to
400 PSI or until the green pump switch light turns on. If you want to use the heater
at a lower PSI, keep dropping the pressure to the desired PSI. If you want to use it
at 500PSI, raise the pressure to 500PSI. Once you go over 500PSI the heater will
automatically turn off.
4.
Allow the heat element up to 3 minutes to preheat cold tap water before beginning
your job. When the heater has reached full temperature, the light on the switch will
turn off. Once you start working, the light will turn on and off as the heater's
temperature monitoring system maintains proper temperature. Using warm water
will yield the hottest results in less time.
WARNING:
•
Do not store the ENDEAVOR at freezing temperatures. Do not expose to freezing
temperatures for extended periods of time. This could cause a rupture of the heater
tank as well as the pump and plumbing.
•
Read and understand this HEATER portion of the owner's manual before using the
HEATER on your ENDEAVOR Extractor.
•
Do not run heater dry.
•
Make sure water is flowing through the heater anytime the heater is on. Failure to do
so may cause internal component damage and will void warranty
•
Turn off the switch when not in use.
•
Do not use heater at more than 500 PSI
•
To avoid explosion and/or fire, do not use solvents or any flammable liquid in heater.