Edic FLOODBUSTER FB50 Podręcznik właściciela/operatora - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik właściciela/operatora dla Scrubber Edic FLOODBUSTER FB50. Edic FLOODBUSTER FB50 17 stron. Professional flood extractor
Drukuj stronę
MACHINE SPECIFICATIONS
PUMP:
submersible, Epoxy-coated steel construction, Nylon Im-
peller, 50 GPM. Handles spherical solids up to ½".
VACUUM:
5.7" 3 stage, high performance
AIR WATTS:
601
AIR FLOW:
110
WATERLIFT:
158"
VACUUM OVERFILL FLOAT SWITCH:
Yes, tilt type float switch
LARGE TANK OPENING:
Yes
HOSE DIAMETER:
1.5" vacuum, 1.5" discharge
REAR WHEELS:
12" Ball Bearing, Non-Marking
FRONT CASTERS:
5" Locking
POWER CORD:
Detachable 12 GA x 25 ft, Twist lock
POWER CONSUMPTION:
120V, 18 Amps
MACHINE WEIGHT:
106 lbs
SETTING UP THE MACHINE BEFORE
OPERATION:
1. Position the machine on a dry place away from the
flooded area. Lock in the casters so that machine does
not change position during operation.
2. Connect your discharge hose (#2 on page 5) to the
discharge hose hookup on the machine (#13 on page
6).
3. Position the end of the discharge hose in a safe drain-
age location. Check local laws and regulations for
proper waste water disposal.
4. Make sure the debris basket with gasket (#3 on page
4) is in place before you position the lid (#1 on page 4)
on the tank. Without the debris basket in position, the
vacuum motor will not create suction.
5. Make sure to tuck the lip on the lid under the metal
bracket
6. Turn the lid locking latch to the closed position.
7. Check on the drain valve and make sure it is fully
closed position.
8. Connect your vacuum hose (#1 on page 5) to the
vacuum intake barb (#2 on page 6).
IMPORTANT:
To ensure a secure lock on the lid:
1. Make sure the lip on the lid is tucked under the metal
bracket.
2. Pivot the lid locking latch (#5 on page 4) over the lid.
Note: To prevent the lid from being lost,
the above steps should also be followed when
transporting the equipment, especially in open air ve-
hicles or trailers.
7