dji AGRAS MG-1S RTK Skrócona instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drony dji AGRAS MG-1S RTK. dji AGRAS MG-1S RTK 20 stron.

AGRAS MG-1S

Quick Start Guide

Flight

Ensure the Flight Mode Switch is in the "F" position and wait for a strong GPS signal. Tap "Start" in the bottom left

corner of the DJI MG app and enter Operation View to start the motors.

Takeoff

Perform the Combination Stick Command (CSC) and then slowly push the throttle stick up to take off.

Landing

To land, pull down on the throttle stick down to descend until the aircraft touches the ground. There are two

methods to stop the motors.

1. When the aircraft has landed, push the throttle down and hold. The motors will stop after 3 seconds.

2. When the aircraft has landed, push the throttle stick down, then perform the CSC command to stop the

motors. Release both sticks once the motors have stopped.

Throttle Stick

Take off immediately after the motors are spinning, or else the aircraft may drift and injure nearby people.

Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or when there are people nearby.

Always keep your hands on the remote controller when the motors are spinning.

Never stop the motors mid-flight unless in emergency situations when doing so can reduce the risk of damage or injury.

When using method 2 to stop the motors, the aircraft may rollover if it doesn't touch the ground completely. Please use it

with caution. Method 1 is recommended for stopping the motors.

After landing, power off the aircraft before turning off the remote controller. Disconnect the cable from the XT90 port and

then the battery communication port.

Throttle Stick